Tweet
I need some advice removing my df140 motor cover. Flipped two rear locks in the down position, and the one on the front of the motor, but still couldn't get it to budge. Could it be hung up somehow? Also, my trim gauge isn't working. Any advice on testing trim sender, and trim gauge?
-
-
Ok I got the cover off finally. It was stcuk to the gasket pretty good, had to budge it from the side. So now im trying to figure out how i can get this trim sender wire retaining screww off. Think it's a #3 phillips and highly torqued on , as you can see it's starting to round off in the grove. Can't get any force behind it becuase the trim cylinder rod is in the way.
Any suggestions
Comment