Tweet
I have a 1997 dt75, it has the factory oil level/warning multigauge. I would like to add an engine temperature gauge, is there a way to tap into the signal feeding the warning gauge for this? Are any of the wires coming from the throttle/shift control box for this?
Ive tried to find diagrams, but the shop manuaive found only shows what should connect where, not which wire is which signal.
I'm also looking if this came with a trim/tilt angle sensor, where would this be located? A lot of the parts diagrams will show parts but not necessarily where they go.
Ive tried to find diagrams, but the shop manuaive found only shows what should connect where, not which wire is which signal.
I'm also looking if this came with a trim/tilt angle sensor, where would this be located? A lot of the parts diagrams will show parts but not necessarily where they go.