Hallo,
First of all a few words about myself.........my name is Graham and I live in
north Germany. I am a couple of years off retirement and have a little boat
which I use on the river Weser/Canals and Lakes where motorboats are still
allowed.
I have a DF15A with handstarter..........this means I have no battery. To use
the SDS software one needs 12V ( turning on ignition ).I have heard that to use
the software with my motor I have to use an external 12 V source. I do not want to fry my ECM so my question is.........what is the best way to do this?
From what I see there are four cables on the SDS connector..........two go to the ECM. I hav`nt found anybody who could say........." I have a handstarter
you must do this" but quite a few " try this or this " .........I hope someone
on this forum can give me a helping hand.
Thankyou in advance to anyone who can find the time to help me out
Greetings from Germany..........Graham
First of all a few words about myself.........my name is Graham and I live in
north Germany. I am a couple of years off retirement and have a little boat
which I use on the river Weser/Canals and Lakes where motorboats are still
allowed.
I have a DF15A with handstarter..........this means I have no battery. To use
the SDS software one needs 12V ( turning on ignition ).I have heard that to use
the software with my motor I have to use an external 12 V source. I do not want to fry my ECM so my question is.........what is the best way to do this?
From what I see there are four cables on the SDS connector..........two go to the ECM. I hav`nt found anybody who could say........." I have a handstarter
you must do this" but quite a few " try this or this " .........I hope someone
on this forum can give me a helping hand.
Thankyou in advance to anyone who can find the time to help me out
Greetings from Germany..........Graham
Comment