Tweet
I'm wiring up a new Suzuki DF300B with the digital electronic controls and a BlueSeas Automatic Charge Relay with Start Isolation for the house battery..
Looking for guidance on where to connect the ACR's Start Isolation wire to a circuit that is only active during start?
Since this engine uses an Automatic Start & Stop Push Button I don't know if the Yellow/Green lead coming out of the start button would work since it just sends a signal to the Boat Control Module for a start sequence.
The SI-ACR and the batteries are located up front under the console so I'd rather not have to run a lead all the way back to the motor if possible.
Suzuki DF300B Wiring Schematic.jpg
Looking for guidance on where to connect the ACR's Start Isolation wire to a circuit that is only active during start?
Since this engine uses an Automatic Start & Stop Push Button I don't know if the Yellow/Green lead coming out of the start button would work since it just sends a signal to the Boat Control Module for a start sequence.
The SI-ACR and the batteries are located up front under the console so I'd rather not have to run a lead all the way back to the motor if possible.
Suzuki DF300B Wiring Schematic.jpg