Tweet
Was pulling into my slip and yanked pull switch by accident and I didn't realize ans tried to start a few times. Then realized and put kill switch back in and tried to start it and now it won't start at all. The motor has power because I can trim it. But when I press the ignition button nothing happens . I did see a quick flash from my screen saying "low voltage" but it went away and I only saw it once. Any ideas ?
-
-
Your trim is fed from a different circuit than the kill switch otherwise you wouldn’t be able to trim the engine up and down with the key in your pocket. The link below explains the white wire.
https://www.suzukioutboardforum.com/...-power-failure
I’m guessing it’s time to check the kill switch.
Comment