Tweet
I've got a 2019 DF250 and my speedometer isn't working. First thing to check is that pressure sensing tubing for kinks and clogs right? That tube is easy to identify on some motors, but I'm having trouble on this one. Anyone got pics or tips to find it?
-
-
-
on the leading edge of your engine about the height of the prop is a small hole.
this easily gets plugged with small debris as the boat runs from place to place ..
all it takes is a piece of small diameter stainless wire to open the hole back up..
ArtComment
-
Yep, that's the first place I went to. Used a tiny drill bit, didn't really get any resistance on it.. I haven't gotten out on the water yet to check. But I was going to keep checking that line if I could find it. Thanks!Originally posted by artdf175 View PostComment
-
-
Try a little air pressure off a compressor
the tube goes straight up from the diagram comes out under the power head and is then in the bundle of wires that heads to the helm .. so there is any number of places it could be pinched or squeezedComment
-
-
That thing didn't have any slack, no wonder it pulled off. It also doesn't seem like a very good design where it exits out top. It's getting pinched. Any thoughts on moving it outside and zip tying it?
IMG_1212.jpgComment
-
that splice joint looks a little suspect.
I would keep it under the cowling
however, think you might be able to find a little longer section of tubing to replace the bottom end that has the zip tieComment
Comment