Hi, Hoping someone can help out. When I turn the key on my DF115 the alarm sounds taco moves up and down but the fuel pump makes a click sound but no priming and the engine won't start. The white wire is good and both neutral switches are working. I am getting 13 volts at the fuel pump, so presumed it was at fault and replaced it but the problem still exists ?
Announcement
Collapse
No announcement yet.
2008 DF 115 fuel pump not priming
Collapse
X
-
There is no relay for the fuel pump, when you turn the key on battery voltage will flow to the pump via a grey wire and the computer will apply a full ground on the black and white ground wire for around three seconds, if it does not receive a signal from the crank sensor when cranking it will remove the ground.
If you heard clicking with just the key on, it might be the main control relay buzzing from low battery voltage, or when you turned the key to start, it will be the starter solenoid dropping in and out from low battery voltage. Does the engine crank over in the start position.
Do this simple test, go to the fuel pump connect an incandescent test light to ground, remove the fuel pump plug and probe the grey wire with the key on it should light, turn the key off connect the test light too battery pos and probe the black and white wire turn the key on it should light for about three seconds and go out, come back on the forum with your results.
Comment
Comment