Suzuki DT4 Re-wiring Coil - Need a little help

[jimmywhale]

Greetings All, I'm super new here so thanks in advance for your patience.

So I just inherited an old DT4 which was running about a year ago and then stored. I'm told it was diagnosed with a dead coil and an OEM replacement has been installed but not wired in, or perhaps even wired incorrectly by the person that donated it to me - who knows even less about outboards than I do....

There is a single blue wire coming out of the coil, and a white and red wire going back up under under the flywheel. In addition there is a blue connector with an empty slot for a male pin (see my labelled attachment).

I had a good dig around for a wiring diagram and couldn't seem to find one.

Can anyone tell me where the blue coil wire and the red and white wire should be routed and connected ?

Thanks in advance !

[Solarman]

You need a wiring diagram for your motor, or similar motor to be sure. But the kill switch/button, or on off switch may be the only change on that circuit?

Good luck.