Hi im new and looking for help please
I have a DT85 non oil injection which i doesnt want to run properly.
Its symptoms are
Rough idle wanting to stall i can keep it running by blipping the throttle,it also sounds like it is spitting back although i dont suspect reed valves.
I thought if i lifted the tickover a little on the carbs i could the adjust mixture and timing.
So i lifted the tickover just a bit and the engine started to rev what sounded like it was past the rev limiter.
I turned the key off but it kept running so i pulled the plug leads off and it was still running then i disconected the fuel BUT it still ran then i flicked the choke on and managed to stop it.
May i say that the throttle was set at idle all the time and the carbs were only just open.
I will say that before i lifted the tickover i always thought that it was very slow to settle back to idle speed if it had just been revved.
This is an engine i have just bought and dont know any of its history.
Would i be right in suspecting an air leak?
Any help will be much appreciated
I have a DT85 non oil injection which i doesnt want to run properly.
Its symptoms are
Rough idle wanting to stall i can keep it running by blipping the throttle,it also sounds like it is spitting back although i dont suspect reed valves.
I thought if i lifted the tickover a little on the carbs i could the adjust mixture and timing.
So i lifted the tickover just a bit and the engine started to rev what sounded like it was past the rev limiter.
I turned the key off but it kept running so i pulled the plug leads off and it was still running then i disconected the fuel BUT it still ran then i flicked the choke on and managed to stop it.
May i say that the throttle was set at idle all the time and the carbs were only just open.
I will say that before i lifted the tickover i always thought that it was very slow to settle back to idle speed if it had just been revved.
This is an engine i have just bought and dont know any of its history.
Would i be right in suspecting an air leak?
Any help will be much appreciated
Comment