Tweet
I am reassembling my 97 DF15 after a valve job. I cannot seem to figure out what keeps the shift rod from sliding to the port side of the motor. If this happens the ball in the actual gear selector will fall out. Any help?
-
-
service manual
very much worth the price -
thanks artdf175 for the response. I have the manual and have just about memorized every word. The drawings are good but i don't find one that shows the parts in question. drawing on page 6-10 shows the clutch lever shaft that I'm concerned about. I do not see what keeps that shaft from moving sideways away from the actual shift lever. My manual is probably different than yours but I thought I'd give it a try. Appreciate your time.
Al WehrenComment
Comment