DF60A Setting the trim levels

[HCDeWet]

Hi.

Can someone please advise the procedure to set the trim levels. I dont have access to a service manual. I will appreciate it.

Does it differ if you have binnacle controls? I do and the video I seen you need to use the warm up lever which my controls dont have. Thanks.

I assume for up and down the same procedure you just press either the up or down button. Thanks again.

[lazypineapple]

is this what your looking for ?





SETTING TILT UP LIMIT POSITION

If the outboard motor contacts the motor well of the boat during

full tilt up operation, the upper limit setting should be reset.

Perform this set-up after the current position setting has been

canceled, as explained in the following procedure.

CANCELING TILT UP POSITION LIMIT SETTING

(1) Turn the ignition key to the “ON” position.

(2) Pull out the emergency stop switch lock plate.

(3) Make sure that remote control handle is in “NEUTRAL”.

(4) Top mount type

Using the throttle only function of the remote control box,

move the control handle forward until the caution buzzer

sounds one time.

Side mount type

Using the throttle only function of the remote control box,

move the warm-up lever upward until the caution buzzer

sounds one time.

(5) Press the “UP” side of the PTT switch for three seconds

and the buzzer will sound twice briefly indicating the setting

has been canceled.

(6) Return the throttle to the fully closed position.

SETTING TILT UP POSITION LIMIT

(7) Press the “UP” side of the PTT switch so that the optimum

full tilt up position for the boat can be obtained.

(8) Turn the ignition key to the “ON” position.

(9) Pull out the emergency stop switch lock plate.

(10) Make sure that remote control handle is in “NEUTRAL”.

(11) Top mount type

Using the throttle only function of the remote control box,

move the control handle forward until the caution buzzer

sounds one time.

Side mount type

Using the throttle only function of the remote control box,

move the warm-up lever upward until the caution buzzer

sounds one time.

(12) Press the “UP” side of PTT switch three times within three

seconds. The buzzer will sound one time briefly indicating

the setting has been accepted.

(13) Return the throttle to the fully closed position and install the

lock plate on the emergency switch. Operate the full tilt up

and full trim down operations several times by pressing the

PTT switch and check that the settings of both the trim

down limit and tilt up limit is properly set.

[HCDeWet]

That is it. Thanks a lot

[HCDeWet]

How do I use the throttle only function with the top mount binnacle controls. I am a bit lost here as there is no warm up lever etc. Thanks

[Solarman]

Not exactly sure what controls you have, but most top mount controls either have a button to push in at the center of the handle, or the handle itself can be pulled out about about 3/4", to engage throttle only.

Provide a pic of your controls and we'd be able to tell better.

Good luck.

[HCDeWet]

Got it. Thanks. Have the button. Button however well hiddeln away. Thanks man.