If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Announcement
Collapse
No announcement yet.
Help! dropped cotter pin in lower unit gear shaft.
I wouldn't think there's any problem. The only place it could have ended up is only exhaust and water exit. It can't get in the gears of move upward toward the powerhead. Tilt/trim it all the way down, put some muffs on it and crank 'er up, It'll likely flush out pretty quick.
PS meant to also say to leave the prop off, as it will only impede the pin's exit.
Comment