I took the carb off, cleaned it all out, soaked the jets and installed a new fuel filter. Put it all back together and the motor won't idle. I am not positive that I pulled the pilot jet near the needle valve when I torn it down. So I did it all again. The pilot jet looks like it has an orifice all the way through but it is so small it is hard to tell. The motor revved up ok, just when you get below start level on the throttle it would sputter and cut out.
Aside from double checking the carb - anything else to look at? Been a few years since it was run.
Thanks
Derek.-
Aside from double checking the carb - anything else to look at? Been a few years since it was run.
Thanks
Derek.-
Comment