Tweet
I have a 2007 df300 with 465 hrs. My PPT relay was bad , trim would not go up but every once in awhile. you could hear the relay clicking , but would go down . So I installed a new , tilt and trim works fine now, but now I have received multiple error codes on the smis gauges , engine would not turn over , alarms going off . I check all my connections again that I took apart , I Check battery connections again make sure they were tight. Even reconfigured the engine on the smis gauges. I'm getting engine hours , voltage,. The codes range from 1-2 , all the way to the 8, and even the check shift control warning and the alarm steadies is beeping every 4 seconds. Does the ECU need to be reprogram. Any info would help thank you.
Comment