New water pump, new thermostat. When I crank it up I get reasonably strong indicator stream, after about a minute, it reduces to a dribble? I thought that maybe I wasn't getting enough water through the muffs, so I have the foot in the water, no difference? I took the thermostat out and hooked up the hose to the flush port, water flows right out the top. I'm confused.
Announcement
Collapse
No announcement yet.
Cooling issue
Collapse
X
-
I'm not sure what size motor you have but on my DT150, the tell tale stream speeds up and slows down as the thermostats open and close, never saw it slow down to a dribble, if its over heating take the lower unit off and check everything again including the tube going up to the motor and the little key in the water pump impeller, you can rig a hose to the tube going up to the motor to simulate the flow, if its not over heating it is most likely all going out the exhaust, some motors just woulnt show a good stream of water unless there deep in the water pocket
-
Comment