Tweet
Sensor said "overheat" on both engines when pulling into dock. Turned them off and restarted......would not rev past 3000 rpms.....both engines....any thoughts?
-
-
3000 rpm is the engines going into safe mode because it is a dual engine they both go once it has cooled down will be ok ...did one of them get a plastic bag over water inlet ? or was there some other cause -
No apparent reason (no plastic bag).....water was still flowing......I've had one sensor overheat......was surprised at both.Comment
-
check your water pump , thermostats , and water pressure relief valve ..
perhaps start with thermostats as most likely cause .
if both motors did not go into fail safe on some application it may go unnoticed that is why both motors are linked so as to give you a warning with a reduction in rpmsLast edited by mitch; 08-15-2010, 08:18 PM.Comment
Comment