If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Mitch what is happening is that my starboard engine dose not want to start after I have been running it . I must start the port up and put the starboard in gear then stop the port then it will usually will start. It has always started so after the messing with it. I have it out of the water now and on observing it I can see that it dosen't start only when it comes back from fwd., from reverse it will start. I think that it is just an adjustment on the fwd handle. But also what just happened was an check engine alarm has started, 4beeps then 2beeps with the flashing of the light.
you need what the light is flashing not the beeps .
4-2 is crankshaft sensor check all the wires are plugged up tight if that is what the light is flashing
have a look where your shift cables come through into engine there is a switch with 2 wires on it ,on gear lever is that depressed when it is in neutral
i was trying to find it on the suzzy parts breakdown but can not see it ?
Comment