If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
i just put on a new/used motor 4 my tilt/trim . its a 1986 suzuki outboard 85hp oil injected. everything is hooked up, filled w/ fluid and motor does not go up or down. whats the problum?
if the motor is working, try turning the release valve clockwise, to good turn in anticlockwise lift thr motor up and check oil level again '''don't to close valve'''
Tweet
Comment