Tweet
hey guys... working on a 95 dt150 efi for a buddy of mine, and having an issue or two.
first off, the motor runs in limp mode with no alarm (right side cylinders have no fire, switched wires, does the same on opposite side so I know coils are good) I don't suspect the cdi of being bad, it was just replaced about two weeks ago. the oil injection system has been removed and I suspect that this could have some effect being that there is no oil sensor anymore. I guess what I need to know is a) whether the oil level sensor throws a code when the sensor completed the circuit or broke the circuit or b) what the wires that were connected to the sensor looked like and where they were routed on the motor so I can start troubleshooting that way. any help would be immensely appreciated and thank you in advance.
mongo
first off, the motor runs in limp mode with no alarm (right side cylinders have no fire, switched wires, does the same on opposite side so I know coils are good) I don't suspect the cdi of being bad, it was just replaced about two weeks ago. the oil injection system has been removed and I suspect that this could have some effect being that there is no oil sensor anymore. I guess what I need to know is a) whether the oil level sensor throws a code when the sensor completed the circuit or broke the circuit or b) what the wires that were connected to the sensor looked like and where they were routed on the motor so I can start troubleshooting that way. any help would be immensely appreciated and thank you in advance.
mongo